Colour Spinner, needs colouring to make the effect look amazing. The two spinners spin in opposite directions creating crazy patterns of colour.
1. Make the design your own and either paint or felt pen the pieces. Grab a screwdriver and some scissors.
2. Prepare wooden parts on the drawing
3. Install the switch first, and then the red wire on one side of the switch and the red wire from the battery box on the other side of the switch. The black wire from the battery box is passed through the hole in the base.
4.The black wire is connected to the left hand side of the motor and the red wire to the right hand side.
5. Assemble No. 1 and No. 2 wood pieces, then the motor and No. 3 wood piece. Secure them with the 7mm screws. Note the motor has the wires facing downwards.
6. Use 7mm screws to fix the bracket from the back of the base, then use 4mm screws to fix the battery box, use a tie wrap the clamp the wires and and cut off the excess.
7. First put the No. 1 and No. 2 metal shafts into the bracket, and use the shaft sleeve to limit the position on the left. One end of the No. 3 metal shaft is put into the main gear, and the other end is inserted into the wood frame.
8.Use 4mm screws to fix the single gear and double-layer Crown teeth on the tuntable respectively. The 70mm metal shaft goes through the single gear, overlaps the turn table, and the Crown teeth go through the metal shaft.
9. The metal shaft goes through the rear frame , and the main gear is located between the two Crown teeth (Note that the gear bite should not be too tight or too loose).
10. Install No. 1 single gear, No. 2 and No. 3 double-layer gear in sequence, and limit the position with shaft sleeve.
Yeah! You’ve finished, put in the batteries and give it go.